Two-phase function principle

With the system solution REPAIR, the costly and time intensive preparation work usually associated with
mould treatment becomes a thing of the past.

Our innovative treatment system enables the direct treatment of the affected areas as long as the base is
still stable.

Hereby no chemical cleaning agents are used which could lead to problems later on. After treatment, the
surface is coated using a special procedure which provides lasting protection against recurring damage.

The effectiveness of the system solution REPAIR is based on innovative product technology in combination
with its special processing method.

 

 

wand0kl

Wall or ceiling areas affected by mould caused by damp and water damage

Residual moisture and mould in building surfaces are often only partially visible as damp, spores and old mould are also found in the deeper layers of the base (e.g. plaster).

wand1kl

First coating phase with BIONI SYSTEM REPAIR

After mechanical wet cleaning, apply solution directly to the affected area. Disinfection with aggressive chemicals is not necessary. Simply paint over visible mould.

wand2kl

Second coating phase with BIONI SYSTEM REPAIRZ

The final coat can take place already the next day. This offers permanent and preventative protection against recurring mould. Any residual moisture in the base can diffuse through the surface of the coating system.